QUESTIONS OR NEED HELP?  Call 1-866-863-2302

Blog

Benefits of Using Screw Feeders or Screw Presenters

What are the the benefits of using Screw Feeders or Screw Presenters in Assembly & Manufacturing?  This post will answer this question and many more around screwing automation. 

Screws aren’t the easiest things to pick and place. Small screws, the kind often used in electronics assembly, are especially difficult, even for workers with delicate fingers. This is why it pays to use screw feeding or presenting systems. Here’s some information about the options.

An Ergonomic Challenge

If you were using screws for a one-off assembly, you’d pick each one out of a box using a pincer grip and insert it into a pre-drilled hole. In some assembly operations the hole might already be threaded, in which case you’ll need to turn the screw back and forth to start the thread. Then you pick up the screwdriver, engage the bit and drive the screw home.

Now imagine doing that dozens of times per hour for an eight-hour shift. Your hand would quickly cramp up, you’d slow down, and you’d make mistakes. Adding a screw presenter or screw feeding system to the assembly operation overcomes this problem.

Two Types of Screw Presenter

 

The simplest system is the screw setter or shaker. This is a panel full of holes the diameter of the screw you’re using. Spread the screws over the panel and give it a shake. The screws will settle into the holes, making it easier to pick them up.

 

The screw presenter is an advance on this. It feeds screws one at a time to a pickup location. If the screws are ferrous a magnetic screwdriver bit will pick up each one as needed. Stainless or other non-magnetic screws can be picked up with vacuum on the screwdriver bit.

 

The Automatic Screw Feeder

 

This screw feeders deliver each screw through a small feed tube to the screwdriver tip. Place it, drive it home and lift up, and the next screw is ready to be inserted. These work with air and electric-powered screwdrivers, both push and lever start.

 

 

Use Cases in Manufacturing

The major benefits of using screw feeders or screw presenters for assembly and manufacturing applications is to reduce cost and speed up production throughput. The screw shaker is useful in low volume manufacturing and assembly work. It improves the ergonomics of the job but doesn’t give a big increase in screws driven per hour. Because it puts each screw in the same location, the screw presenter speeds up the assembly task and so raises productivity. Use this in a medium volume assembly operation.

The ultimate in screw automation is the feeder. Delivering each screw right to the screwdriver tip eliminates repeated moves between assembly task and pickup location, so improving assembly efficiency. This is the tool for high volume assembly work.

Justifying the Investment

The primary gain is the number of screws that can be driven per hour, but there are other benefits too. Eliminating ergonomic problems improves the job and prevents absences due to wrist injuries. Third, less fatigue means fewer mistakes. As one screw driving mistake can scrap a whole assembly this can be a big saving!

Express Assembly can help you decide which screw feeding system is right for your operation. Contact Us or call 1-866-864-2303.