Question: If we are using the torque screwdrivers for panel mounting components that are using self-tapping screws, will I limit out on torque producing the initial tapping versus the torque needed for final seating of a screw?

 

The technical answer is if the end torque is higher than the self-tapping torque you should be all set.  This is true for large screw but hard to know for smaller screws.  What we recommend is to purchase a driver that meets your end torque specification and try it out.  We have a 30 day evaluation period so if it does not work we will take the driver back. 


Comments are closed.


EXPRESS ASSEMBLY PRODUCTS, LLC · ONE CHESTNUT STREET, SUITE 215 • NASHUA NH 03060
TOLL FREE 1-866-863-2302 · (603) 578-9965 · FAX (603) 424-5595  · INFO@EXPRESSASSEMBLY.COM
connect with us on LinkedIn
connect with us on LinkedIn
RSS Feed
Subscribe to me on YouTube
© Copyright 2005-2019 Express Assembly Products LLC. All rights reserved. The text and photographs contained in this material are copyright protected and may not be copied or reproduced, in whole or in part, without the express written consent of Express Assembly Products LLC.